How do I get true reflective surfaces? Looking in the cargo bay it looks like I am seeing the inside of the bay.
But when I launch you can see the ground rather than the inside of the bay.
It is almost like it is 90 degrees? out. So the reflection are on the z axis?
in the scn. this is the vessel:
STS-51G:Shuttle2016BEARLY
In the cfg/GC folder I have a file:
Shuttle2016BEARLY.cfg
that lists the different meshes
CONFIG_VERSION 2
; =============================================
MESH 2016SPACESHUTTLE\Challenger\Challengerlate2016H2
; ---------------------------------------------
MATERIAL 2
REFLECT 0.866667 0.866667 0.866667
ROUGHNESS 1.00000000
; =============================================
; =============================================
MESH 2016SPACESHUTTLE\Discovery\Discoverylate2016H2
; ---------------------------------------------
MATERIAL 2
REFLECT 0.866667 0.866667 0.866667
ROUGHNESS 1.000000
; =============================================
...
and another file:
Shuttle2016BEARLY_ecam.cfg
BEGIN_CAMERA 0
LPOS 0.0 0.0 0.0
DO_NOT_OMIT_FOCUS
END_CAMERA
Where should this be:
LPOS 0.0 0.0 0.0
I noticed the SSU has it at:
LPOS 0.0 0 8.75289
But when I launch you can see the ground rather than the inside of the bay.
It is almost like it is 90 degrees? out. So the reflection are on the z axis?
in the scn. this is the vessel:
STS-51G:Shuttle2016BEARLY
In the cfg/GC folder I have a file:
Shuttle2016BEARLY.cfg
that lists the different meshes
CONFIG_VERSION 2
; =============================================
MESH 2016SPACESHUTTLE\Challenger\Challengerlate2016H2
; ---------------------------------------------
MATERIAL 2
REFLECT 0.866667 0.866667 0.866667
ROUGHNESS 1.00000000
; =============================================
; =============================================
MESH 2016SPACESHUTTLE\Discovery\Discoverylate2016H2
; ---------------------------------------------
MATERIAL 2
REFLECT 0.866667 0.866667 0.866667
ROUGHNESS 1.000000
; =============================================
...
and another file:
Shuttle2016BEARLY_ecam.cfg
BEGIN_CAMERA 0
LPOS 0.0 0.0 0.0
DO_NOT_OMIT_FOCUS
END_CAMERA
Where should this be:
LPOS 0.0 0.0 0.0
I noticed the SSU has it at:
LPOS 0.0 0 8.75289
Last edited: